--- 2 ---
4-1. Selling Point Descriptions
(1) Adjusting and locking the base
The base must be adjusted when cutting in a circle using the optional circular guide, when cutting out
shapes, or when bevel cutting. The Model CJ 110V requires no tool for adjusting and locking of the base.
Adjust and lock the base according to the following procedure.
1 Turn the base handle just under the housing about 90˚ to loosen (Fig. 1).
2 Move the base forward or backward if necessary. For bevel cutting, align the horizontal groove on
the half-round portion of the base to the mark on the gear cover to incline the base. The base can be
inclined to either side (right or left) up to 45˚. The half-round portion is calibrated from 0˚ to 45˚ in
increments of 15˚. The base can be easily inclined by adjusting the mark on the gear cover to the
desired calibration (Fig. 2).
3 Turn the base handle about 90˚ in the direction opposite to 1 to lock the base and secure the base
handle to the original position just under the housing (Fig. 1).
Fig. 1
Fig. 2
Base handle
Loosen
Tighten
90˚
Base handle
mark on the
gear cover
Scale on the half-round portion
Groove on the half-round portion
Mark on the gear cover
