Hirschmann RSPE30, Руководство пользователя

Страница: 47 / 74

Installation RSPE30/32/35/37
Release 16 04/2019
47
For every supply voltage to be connected, perform the following steps:

Remove the terminal connector from the device.

Connect the wires according to the pin assignment on the device with the
clamps.

Fasten the wires in the terminal block by tightening the terminal screws.
 You find the prescribed tightening torque in chapter:
“General technical data” on page 55
With a non-redundant supply of the supply voltage, the device reports the
loss of a supply voltage. You can prevent this message by applying the
supply voltage via both inputs, or by changing the configuration in the
Management.
2.6.5 Signal contact

Connect the signal contact lines with the terminal block connections.

Fasten the wires in the terminal block by tightening the terminal screws.

You find the prescribed tightening torque in chapter:
“General technical data” on page 55