Hirschmann OCTOPUS 16M-8PoE-2FX, Руководство пользователя

Страница: 7 / 44

OCTOPUS 8M/16M/24M/OS32
Release 10 05/2012
7
The supply voltage is electrically isolated from the housing.

Use undamaged parts.

Only use voltage supply cables with the permitted diameter specified
by the manufacturer of the right angled cable socket.

Relevant for North America:
Devices without Power-over-Ethernet (PoE) may only be connected to
a supply voltage of class 2 that fulfills the requirements of the National
Electrical Code, Table 11(b). If the voltage is being supplied
redundantly (two different voltage sources), the combined supply
voltages must fulfill the requirements of the National Electrical Code,
Table 11(b).

Relevant for North America: For use in Class 2 circuits.
Only use copper wire/conductors of class 1, 75 °C (167 °F).

Relevant for North America
for devices certified for hazardous locations:
Power, input and output (I/O) wiring must be in accordance with
Class I, Division 2 wiring methods [Article 501-4(b) of the National
Electrical Code, NFPA 70] and in accordance with the authority having
jurisdiction.

Shielding ground
Note: The shielding ground of the connectable twisted pair lines is
connected to the housing as a conductor.

Beware of possible short circuits when connecting a cable section with
conductive shielding braiding.

Housing
Only technicians authorized by the manufacturer are permitted to open
the housing.
The device is grounded via the separate ground screw.

Make sure that the electrical installation meets local or nationally
applicable safety regulations.
WARNING
RISK OF BURNING
The surfaces of the device housing may become hot. Avoid touching the
device while it is operating. Wait until the device has cooled down.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.