Hirschmann OCTOPUS 16M-8PoE-2FX, Руководство пользователя

Страница: 26 / 44

26
OCTOPUS 8M/16M/24M/OS32
Release 10 05/2012

Connect the cable shield to the connector housing.

Seal all unused ports with locking screws.
(see page 40 “Accessories”)

10/100 Mbit/s twisted pair connection for PoE
(4-pin M12 sockets)
10/100 Mbit/s TP PoE ports enable the connection of terminal devices or
independent network segments according to the IEEE 802.3 10BASE-T/
100BASE-TX and IEEE 802.3af (Power over Ethernet) standards.
These ports support:
 Autonegotiation

Autopolarity
 Autocrossing (if autonegotiation is activated)
 100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode

10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
 Power over Ethernet (PoE)
Delivery state: autonegotiation activated
The socket housing is electrically connected to the housing.
The PoE voltage is input via the wire pairs transmitting the signal
(phantom voltage).

Install the data lines according to your requirements.

Use a shielded CAT5 cable or better.

Use a shielded 4-pin M12 plug.

Connect the cable shield to the connector housing.

Seal all unused ports with locking screws.
(see page 40 “Accessories”)
Figure Pin Function PoE(PSE)
1 TX+ Transmit Data + +
2 RX+ Receive Data + −
3 TX − Transmit Data − +
4 RX − Receive Data − −
Housing: shield
Table 5: Pin assignment of the TP/TX interface for PoE for the voltage supply to
the wire pairs transmitting the signal (M12 socket)