Hioki MR8904, Инструкция по эксплуатации

Страница: 11 / 72

1.1 Features
7
The MR8904 is an input module for Memory HiCorder that captures necessary data from CAN bus sig-
naling and transfers analog or logic signals to a Memory HiCorder as waveform data.
• When you connect the Memory HiCorder to a PC with a USB cable, you can configure the MR8904
from the PC with the MR8904 CAN Editor application (the USB cable and application are included with
the Memory HiCorder).
• Up to 200 CAN definitions can be registered.
The MR8904 is a Memory HiCorder option. It should only be used when installed in a Memory HiCorder.
Supported models: MR8875
The MR8904 provides an extensive number of output channels, including 15 analog channels
and a 16-bit logic channel.
The device’s independent CAN1 and CAN2 ports allow it to be connected to different net-
works with different CAN bus types or baud rates.
A single MR8904 provides support for three types of CAN bus: high-speed CAN, low-speed
CAN, and single-wire CAN.
The MR8904 monitors the CAN bus and automatically configures the baud rate accordingly,
eliminating the need to make troublesome settings (12 baud rates are supported: 10k, 20k,
33.3k, 50k, 62.5k, 83.3k, 100k, 125k, 250k, 500k, 800k, and 1 Mbps). The baud rate can also
be set manually.
Advanced settings concerning data captured from the CAN bus can be configured with the
MR8904 CAN Editor, an application featuring exceptional usability.
The MR8904 converts CAN signals into analog and logic data in real time, allowing signals to
be observed as waveforms on the Memory HiCorder.
Product Overview
Chapter 1
1.1 Features
Extensive number of output channels
Two independent input ports
Support for three types of CAN bus
Automatic baud rate configuration
PC-accessible advanced settings
Real-time waveform observation