Hioki 3290-10, Инструкция по эксплуатации

Страница: 21 / 152

1.3 Identification of Controls and Indicators
15
1
2
3
4
5
6
7
8
9
10
11
O
vervi
ew
• Suspends or deactivates the display-updating function.
• Holding down the button and turning power on disables the auto
power-off function.
(see page 104)
• Press and hold for two seconds to store settings and data.
(See page 101)
• When TIME is displayed (other than when current is displayed), after pressing
button, press the buttons to review INTEG, RATE or PEAK mea-
surement history.
(see page 97)
LOCK
(
SHIFT
→
):
(see page 103)
• Locks all buttons including the button.
• To cancel, press SHIFT button again, then press button.
• Displays the integral and interval mean current values
(see page 74)
DC Mode: total integral
→
positive integral
→
negative interval
→
interval mean value
AC and AC+DC Modes: integral
→
interval mean value
• Holding the button while pressing the button to turn the meter
on disables the beeper.
(see page 107)
START/STOP
(
SHIFT
→
):
(see pages 74 and 85)
• Starts and stops current integral and duty measurement.
When
STOP
is displayed, measurement starts (and
START
appears)
When
START
is displayed, measurement stops (and
STOP
appears)
•
TIME
is displayed.
• Displays elapsed time from when measurement was started by the START/STOP
button, the timer setting and repetition number (alternating once per second).
Elapsed time
→
timer setting and repetition number
Elapsed time is displayed normally up to 99 hours and 59 minutes.
If the total time of repeating timer measurements exceeds 100 hours, the time
unit indicator (h) is displayed.
• The button has to be pressed in order to set the timer.
INPUT/SET
(
SHIFT
→
):
(see pages 67 and 82)
• Enables the setting display for the timer and current threshold (only for duty
measurement).
• Accepts displayed settings.
• Displays the duty, operating time and current threshold
(see page 81)
Duty
→
operating time
→
current threshold
• Although no "%" unit indicator appears for duty measurements, the displayed
value is percentage.
• When the duty value exceeds 100 hours, "h" is displayed to indicate hour units.
Press the button to display.
• The button has to be pressed in order to set the current threshold.
OUTPUT
(
SHIFT
→
):
(see pages 54 and 71)
• Makes output settings (for current and integral measurements).
• Settings for the two output jacks are limited according to measurement mode.
• The auto power-off function is disabled. However, when the timer is set, data is
stored and power turns off about 10.5 minutes after the timed measurement
ends (stored data can be read by pressing
SHIFT + buttons).