Installation Instructions for:
105295-HEI Kit
Gen1 to Gen5
Control System
I
NSTALLATION
P
ROCEDURES
Components of Kits 105289 and
105290:
Screw – HHC, 1/4-20 x x0.75 inch
P/N Z0186
Qty. 4
Washer – Lock ¼ inch
P/N Z0188
Qty. 4
Controls - Platform, Gen 5
P/N 100840-HEI
Qty.1
Mount – Platform Controls
P/N 105990
Qty.1
Bumper – Rubber
P/N 43392
Qty.2
Screw – RHM, 8-32 x 0.5 inch
P/N Z075
Qty.1
Washer – Flat, #8
P/N 90126A512
Qty.1
Nut – Nylock, 8-32
P/N 90675A009
Qty. 1
Procedure
1. Tag and disconnect the platform controls wire
harness from the control cable at the platform main
deck.
2. Models with foot switch: Tag and disconnect the
platform controls wire harness from the foot switch.
Models with security latch:
3. Release the latch and remove the platform controls
from the machine.
4. Remove the catch bracket, used to secure the
platform controls to the platform, from the side of
the platform controls mount bracket. Set the catch
to the side. Discard the fasteners.
5. Using the provided 8-32 screw, washer and nut
(P/N Z075, 90126A512, and 90675A009). Install the
catch bracket, removed in step 4 onto the provided
platform controls mount (P/N 105990) in
approximately the same location it was installed
previously. Securely tighten the fasteners. Do not
over tighten.
6. Remove and discard the three joystick mount
buttons from the platform railing.
All models:
7. Using the provided 1/40-20 fasteners (P/N Z0186
and Z0188), install the provided platform controls
(P/N 100840-HEI) onto the mount from step 5.
8. If required and working from the inside of the
platform, install the provided rubber bumpers (P/N
43392) in to the two holes in the platform support on
the railing.
Install the platform controls onto the platform railing.
Secure the latch on to the catch bracket (if equipped).
9. Using dielectric grease in the connectors, securely
connect the platform controls wire harness to the
control cable at the platform main deck.
10. Models with foot switch: Using dielectric grease
in the connectors, securely connect the platform
controls wire harness to the foot switch.
P/N 105294-HEI Rev.0
HEI
4/ 16
