HIMA HIMatrix F31 02, Руководство пользователя

Страница: 29 / 48

F31 02 4 Start-Up
HI 800 147 E Rev. 1.01 Page 29 of 48
4.2 Configuration
The controller can be configured using a programming tool, SILworX or ELOP II Factory.
Which programming tool should be used, depends on the revision status of the operating
system (firmware):
ƒ ELOP II Factory is required for operating system versions prior to 7.
ƒ SILworX is required for operating system version 7 and beyond.
i
ELOP II Factory is required to load a new operating system (version 7 or beyond) into a
controller with a CPU operating system version prior to 7. SILworX is then required once
the loading procedure is completed.
4.3 Configuring a Remote I/O with SILworX
In the Hardware Editor, the controller is represented like a base plate equipped with the
following modules:
ƒ Processor module (CPU)
ƒ Communication module (COM)
ƒ Input module (DI 20)
ƒ Output module (DO 8)
Double-click the module to open the Detail View with the corresponding tabs. The tabs are
used to assign the global variables configured in the user program to the system variables.
4.3.1 Parameters and Error Codes for the Inputs and Outputs
The following tables specify the system parameters that can be read and set for the inputs
and outputs, including the corresponding error codes.
In the user program, the error codes can be read using the variables assigned within the
logic.
The error codes can also be displayed in SILworX.