Hilti TE 76, Руководство по эксплуатации

Страница: 24 / 26

19
11. Trouble shooting
Symptom Possible cause Possible solution
The tool doesn’t start Fault in the electric power supply Plug in another electric tool and check
whether it starts
Defective supply cord or plug Have it checked by an electrical
specialist and replace if necessary
Switch defective Have it checked by an electrical
specialist and replace if necessary
The tool doesn't start and the The tool has not been activated Use the activation key to activate the
indicator lamp blinks yellow. (tools with optional theft tool.
protection system).
No hammering action The tool is too cold Allow tool to reach the minimum
operating temperature
See section “Preparation for use”
Tool doesn’t produce full Cross-section of the Use an extension cord of adequate cross-
power extension cord is inadequate sectional area. See section “Preparation
for use”
Power selector switch is set Move the power selector switch to
to position I position II

Control switch is not pressed fully Press the control switch as far as it will go
Drill bit doesn’t rotate The function selector switch is not Move the function selector switch
locked in the drilling position (when the motor has stopped) to the
( ) drilling position ( )

Drill bit cannot be released Chuck locking sleeve is not Pull the chuck locking sleeve back as far
from the chuck pulled back fully as it will go and pull out the insert tool
Side handle is not fitted Release the side handle and fit it
correctly correctly so that the clamping band
and side handle are positioned
correctly in the locating groove

12. EC declaration of conformity
Description: Combihammer
Designation: TE 76 / TE 76P /
TE 76-ATC / TE 76P-ATC
Year of design: 1999
We declare, under our sole responsibility, that this product
complies with the following standards and directives:
89/336/EWG, 98/37/EG, EN 55014-1, EN 55014-2, EN
61000-3-2, EN 61000-3-11, EN 60745-1, EN 60745-2-6
Hilti Corporation
Peter Cavada Matthias Gillner
Head of BU Head of BA
Quality and Process Management Electric Tools & Accessories
BA Electric Tools & Accessories
01/2007 01/2007
Printed: 07.07.2013 | Doc-Nr: PUB / 5071194 / 000 / 00