Hilti PM 2-LG, Руководство пользователя

Страница: 27 / 412

*2341494*
2341494 English 19
2. Press the line mode button repeatedly until the desired line mode is set. → page 18
▶ The product repeatedly cycles through the operating modes in the following sequence: horizontal
line, vertical line, all lines.
When the "Inclined line" function is active, the pendulum is locked and the laser is not leveled.
The laser beam(s) flash every 5 seconds.
5.5 Switching the laser beams off
1. Set the selector switch to the OFF position.
▶ The laser beam is switched off and the pendulum is locked.
CAUTION
Risk of injury by unintended starting!
▶ Before inserting the battery, make sure that the product is switched off.
2. The laser beam is switched off automatically when the battery is low.
5.6 Examples of applications
5.6.1 Transferring heights 3
5.6.2 Aligning drywall tracks 4
5.6.3 Aligning overhead lights 5
5.6.4 Aligning pipes 6
5.6.5 Aligning heating units 7
5.6.6 Aligning door and window frames 8
5.7 Activating or deactivating laser receiver mode
The range of the laser receiver might be restricted on account of the design-related asymmetry of the
laser power and possible disruptive external light sources.
To optimize the range, work on the strong side of the line laser and avoid working in direct light. The
strong side is the front of the line laser.
1. To activate the receiver mode, press the receiver mode button.
▶
The laser beam flashes five times as confirmation.
▶ The LED beside the receiver-mode button shows green.
▶ The visibility of the laser beams diminishes.
2. Press the receiver mode button again to deactivate the receiver mode.
▶ The LED beside the receiver-mode button goes out.
▶
The visibility of the laser beams increases back to normal level.
Receiver mode is deactivated when the laser is switched off.
5.8 Checking
5.8.1 Checking the leveling of the laser beam 9
1. The distance between the walls must be at least 10 m.
2. Set the laser on a flat, horizontal surface approx. 20 cm from wall (A) and project the point of intersection
of the laser lines on to wall (A).
3. Mark the point of intersection of the laser lines with a cross (1) on wall (A) and with a cross (2) on wall (B).
4. Place the laser on a flat, horizontal surface approx. 20 cm from wall (B) and project the point of
intersection of the laser lines on to cross (1) on wall (A).
5. Adjust the height of the point of intersection of the laser lines so that the point of intersection coincides
exactly with mark (2) on wall (B). Use a tripod or a wall mount if necessary.