*2328430*
2328430
English
27
6.6 Installing the rail and flush-cutting saw head
@
144 mm + approx. 5 mm
;
235 mm + approx. 5 mm
▶
When installing, make sure that the saw
blade does not come into contact with the
material, as otherwise friction losses would
reduce the saw's performance.
▶
Allow approx. 5 mm of extra clearance
between saw blade and material, or use
the leveling screws rail support to set the
saw to a slight angle.
6.7 Extending tracks
Always use only the accessories intended for the purpose to extend the tracks.
@
Rail
;
Tapered connector
=
Eccentric pin
%
1/2" square pin wrench
&
Tapered sleeve
1. Clean the tapered connector and tapered sleeves and then grease these parts.
2. Insert the tapered connector in the track and tighten the eccentric pin by turning it in
clockwise with the 1/2" square wrench.
The track extension can be removed by releasing the eccentric pin by turning it
in counterclockwise and pushing out the tapered connector.
Содержание DST 20-CA
