*2328430*
2328430
English
41
5. Blow out the cooling circuit. → page 41
6. Remove the saw head from the track.
7. Remove the guide track.
8. Dismantle / remove the track supports.
9. Clean all components and check them for damage.
10.Stow the components on the transport trolley and secure them all in position.
9.5 Blowing out the cooling circuit
To avoid frost damage when there is a risk of frost, the cooling circuit must be blown
out after completion of the work or before long pause between periods of work.
@
Blow-out adapter
;
Pump hose
1. Push the pump hose onto the blow-out adapter as far as it will go.
2. Connect the blow-out adapter to the water supply connector on the saw head.
3. Applying at least 8 strokes of the pump, blow out the saw head until no further water
is ejected.
To release the pump hose from the blow-out adapter, press down the release
ring on the adapter and pull the hose out of the blow-out adapter.
10
Care and maintenance
WARNING
Electric shock hazard!
Attempting care and maintenance with the supply cord
connected to a power outlet can lead to severe injury and burns.
▶
Always unplug the supply cord before carrying out care and maintenance tasks.
WARNING
Risk of personal injury and damage to the equipment or other property!
Water finding
its way into the saw may result in damage to the saw and increase the risk of electric shock.
▶
Do not use a high-pressure water-jet cleaning system to clean the saw head, remote
control unit or cables.
▶
Clean the entire set of equipment immediately after finishing work and before long
breaks between periods of use. Do not allow slurry to dry and adhere to the parts.
Содержание DST 20-CA
