Hilti DD-400E, Руководство по эксплуатации

Страница: 13 / 48

13
9.4 Mounting the carriage on the rail
2
1
3
1. Carriage
2. Rail
3. Feed movement locking mecha-
nism
The feed movement locking mecha-
nism must face the direction of drilling.
Note: Always keep the feed move-
ment locking mechanism in the closed
position when the carriage is not in
use!
9.5 Fitting the end stop (clamping piece) on the rail
1 2 3 4
1. Rail
2. Steel bar
2. Engaging teeth
4. Clamping screw
The use of an end stop is mandatory
for drilling overhead and on walls.
9.6 Adjusting the rail angle
2
3
45˚
4
1
1. Baseplate
2. Baseplate taper for angular drilling
3. Clamping screw
4. Wrench
Secure the column (guide rail) to pre-
vent it from falling when the clamping
screw is released.
9.7 Extending the guide rail
1. Rail
2. Rail extension
3. Taper
4. Eccentric pins (2)
5. Wrench
2
1
3
4
5
9.8 Fitting the bracing spindle and taper
2
1
3
4
6
5
1. Rail
2. Eccentric pin
3. Wrench
4. Taper
5. Spindle
6. Locknut
9.9 Mounting the motor unit on the carriage
3
5
2
1
4
6
1. Motor unit
2. Motor unit mount
3. Carriage
4. Mounting surface
5. Eccentric clamping pin
6. Wrench
– Supply cord support
– Water hose support
Caution:
– Do not pinch the supply cord!
– Ensure that the baseplate and guide
rail are secured rigidly before moun-
ting the motor unit!
Removing the motor unit: Hold the
motor to prevent it from falling when
the eccentric clamping pin is pulled
out.
9.10 Fitting the handwheel
2
1
3
4
1. Carriage
2. Connecting boss
3. Handwheel
4. Clamping screw
The handwheel can be fitted on either
side of the carriage.
9.11 Fitting a core bit
OPEN
CLOS
E
2
1
3
4
5
1. Chuck
2. Connection end
3. Core bit
4. Locking sleeve
5. Motor unit
Printed: 07.07.2013 | Doc-Nr: PUB / 5069604 / 000 / 00