hilscher CIFX M223090AE-CO/F, Руководство пользователя

Страница: 16 / 48

Installing the hardware 16/48
Component heights
·
The component height on the upper side of the basic card CIFX
M223090AE is higher than the height of 1.5 mm specified by the
standard because the height of the cable connectors (Ethernet X801, or
fieldbus X802) including the cable is approx. 8.5 mm above the printed
circuit board.
·
The component height on the bottom side of the basic card CIFX
M223090AE complies with the standard specifications.
Panel dimensioning
·
Panel cut-outs and holes for mounting AIFX
To mount the detached network interface CANopen, the required panel
cut-outs for the communication status LEDs and the CANopen plug, as
well as the holes for mounting the AIFX, must be available on the
housing of the PC or connecting device.
Panel cut-outs The layout for the panel cut-outs must be sufficiently
dimensioned for:
·
The CANopen interface, DSub plug
·
The CAN communication LED
Drill holes 2, at a distance of 25.0 mm
Further information The dimensions for the required panel cut-outs or the distance
of the holes can be found in the dimension drawing for the
AIFX, see section
Dimensions AIFX-V2-CO [
}
page 36].
Table 10: Panel cut-outs and holes for mounting AIFX
·
The width of the front panel
When dimensioning the front panel, note the width of the front panel
specified in section
AIFX-V2-CO [ } page 32] .
CIFX M223090AE-CO\F | Hardware description and installation
DOC210203UM02EN | Revision 2 | English | 2021-09 | Released | Public © Hilscher 2021