Hillstone SG-6000-X7180, Справочник по аппаратуре

Страница: 58 / 64

50
Chapter 5 Hardware Maintenance and Replacement
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
2. Remove all the cables connected to the module.
3. Use a Phillips screwdriver to loosen IOM screws until they pop out.
4. Hold the screws and pull the IOM straight out of the chassis, as shown in Figure
5-4.
Figure 5-4: Replacing an IOM (IOM-16SFP)
5. Put the removed module into an antistatic bag or on a flat antistatic table.
6. Install a replacement module (see Installing an IOM ).
Note: If you do not want to install a new module, apply a blank plate over the slot to
avoid dust falling into the chassis.
Replacing a Bypass Module
To replace a bypass module, take the following steps:
1. Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
ESD Prevention .
2. Remove all the cables connected to the module.
3. Use a Phillips screwdriver to loosen IOM screws until they pop out.
4. Hold the screws and pull the IOM straight out of the chassis, as shown in Figure
5-5.