33
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
5.
Position the QSM so that its front side faces you, and slide the QSM into the slot
until you feel resistant, as shown in Figure 3-6.
Figure 3-7: Installing a QSM (QSM-20)
6.
Tighten the screws on the QSM with a Philips screwdriver.
7.
To install more QSMs, repeat Step 2 to 6.
Installing an IOM
IOM has four types and should be installed in Slot1 to Slot10, but the IOM-
and IOM-8SFP+ module cannot be installed in the Slot7 expansion slot.
The following section takes IOM-16SFP as an example to describe the installation of
IOM.
To install an IOM, take the following steps:
1.
Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
2.
Take the IOM out of its antistatic bag.
3.
Identify the slot of IOM.
4.
If the slot is covered with a blank plate, loose its screws with a Philips
screwdriver and remove the plate.
5.
Position the IOM so that its front side faces you, and slide the IOM into the slot
until you feel resistant, as shown in Figure 3-7.
