Hill-Rom 2040005, Руководство по обслуживанию

Страница: 98 / 104

Service Manual Viking™M mobile lift • 3EN370401 Rev. 19 98 www.hill-rom.com
l
www.liko.com
Instructions regarding the check points
Remove link arm cover, bolt and nut.
Clean, lubricate and reassemble pivot bolt, bearing sleeves and hardware.
Inspect the legs at the linkage. If the linkage are in poor condition, replace them
with Restoration set motor attachment .
(For Spare Part No, see the Spare Parts List)
Reconnect actuator to link arm. Apply plastic hardware covers.
X
Y
Z
x2
Restoration set motor attachment
6 Base motor linkage
7 Lift arm
x2
x6
x3
x6
x2
Overhead beam Restoration set
(For Spare Part No, see the
Service Manual.)
Remove hardware covers.
Remove and lubricate lift arm bolt.
Visually inspect lift arm, plastic covers
for wear, cracks or deformation.
Reassemble in reverse order.
Run the lift arm a full lift cyckle without load and make sure it moves freely.
Make sure the arm is not binding. If the arm does not fall to the lowest position, the screw is too tight.
Remove and lubricate actuator hardware. Visually inspect actuator plastic bushings
for wear. Replace if worn. Reassemble in reverse order.
10.0