Hill-Rom 2040005, Руководство по обслуживанию

Страница: 91 / 104

Service Manual Viking™M mobile lift • 3EN370401 Rev. 19 91 www.hill-rom.com
l
www.liko.com
Instructions for the check points
X¹ X²
4 Castor brakes
- Lock the brakes. Make sure the wheels do not turn and the castor housing does not swivel when the lift is pushed.
5 Base covers
- Verify that the protective plastic covers are secure.
6 Base opening and closing linkage
- Inspect the linkage between legs and base motor. Make sure there is no cracks or deformations at the legs.
- Inspect the plastic protective cover shell for cracks, deformation or gaps.
- Open and close the base to maximum and minimum dimensions.
- Listen for peculiar noises and vibrations
7 Base frame castor play and levelling
- Manually open and close legs at the front castors to measure wheel play. Base width wheel play should not
exceed 35mm / 1,38 Inch total.
8 Locking handles
- Loosen & re tighten locking handles. Verify that threads are not damaged or binding.
9 Lift arm hardware and covers
- Run the lift arm a full lifting cyckle without load and make sure the arm is not binding and moves freely. If the arm is binding
the mounting screw is to tight.
- Inspect the plastic protective cover shells for cracks, deformation or gaps.
- Make sure the holes in the mast are not deformed on:
Product Product No. Up to S/N:
Viking™ XL mobile lift 2040003 801 999
Viking™ L mobile lift 2040004 7 200 795
Viking™ M mobile lift 2040005 7 106 200
Verify that the diameter of the holes in the mast
(where the arm and mast is connected) are not bigger than 12 mm/0,47 inch.
It can be done by measuring the distance from cover hat, to top of the“ear”.
The length should be the same on each side (X¹=X²)±1 mm.
10 Flexlink to arm hardware and covers
- With the slingbar hanging in it’s lowest position, manually raise the slingbar and flexlink arm.
- Verify that the flexlink arm lowers and raises freely. If the flexlink is binding the screw is too tight.
- Inspect the plastic protective cover shells for cracks, deformation or gaps.
11 Flexlink to slingbar hardware and covers
- With the slingbar hanging in it’s lowest position, manually pivot the slingbar side-to-side. Verify that the flexlink
arm lowers and raises freely. If the flexlink is binding, the mounting screw is too tight.
- Verify that hardware covering plastic caps are secure.
- If no accessories is attached, verify that the slingbar is assembled directly to the flexlink.
9.0