Network Traffic Camera User Manual
47
Chapter 11
Capture Parameters
Configuration
Purpose:
You can configure flash light and vehicle feature on this page.
11.1
Configure Flash Light Parameters
Steps:
1.
Go to
Configuration > Device Configuration > Capture Parameters > Flash
Light Parameters
.
2.
Select a tab corresponded with the flash light control port.
The camera supports IO:1 and IO: 2.
IO:1 is the built-in flash light. IO:2 is the extra flash light.
Figure 11-1
Flash Light Parameters Configuration
3.
Select
IO Output Mode
.
Constant Light Mode
is available.
Constant Light Mode
1)
Input
Duty Ratio
. It controls the power level of the flash light. 0 means
light off, 70 means full-power.
2)
Set light on/off control mode. The on/off status can be controlled
automatically or on schedule.
Auto: Check
Control Constant Light By Brightness
. Set the brightness
threshold.
Schedule: Check
Control Constant Light by Schedule
. Set the start time
Содержание iDS-TCM403-AI
Страница 1: ...User Manual of Network Traffic Camera 0 Network Traffic Camera User Manual...
Страница 74: ...73 Figure A 1 2 Modify Network Parameters...
Страница 75: ...74 UD13303B...