HIKVISION iDS-TCE500-B/1550, Руководство по настройке, Страница: 46 / 73

It is the dwell time [0 to 10000 μs] after the flash light responds. The actual flash light
supplement time is the result of the dwell time minus advanced time.
Effective Status
Select the effective status of the supplement light according to the actual condition.
High/Low
When high/low level signal is output to the supplement light, the light will flash.
The effective status should stay different with the default status for I/O to take effect. And
the default status changes according to the selection of the effective status. If you set the
effective status as high level, the default level goes to low level.
Pulse
When pulse signal is output to the supplement light, the light will flash.
If you set the effective status as pulse, you can select the default status as high level or low
level, and set Frequency Coefficient which is the frequency multiplication of 25 of output
pulse by flash light, to keep the flash light as constant. You can set it as default value.
Light Compensation Mode
Select Checkpoint to enable checkpoint capture light supplement. Select Violation Action to
enable violation capture light supplement.
Duty Ratio
It is the time occupation of the high level in a certain period. The higher the duty ratio, the
brighter the solid light. High duty ratio will cut life span of the solid light.
3. Set the supplement light control mode.
-
Select Default to disable the supplement light.
-
Select Time Schedule when you want the supplement light to be enabled during a fixed time
period. Set the start time and end time.
-
Select Environment Brightness when you want the supplement light to be controlled by
detecting the surroundings brightness automatically. Set the brightness threshold. The higher
the threshold is, the harder the supplement light can be enabled.
-
Select License Plate Brightness when you want the supplement light to be enabled according
to the license plate brightness automatically. It is valid only when you select Effective Status
as Pulse.
Note
The four modes conflict with each other. You can only enable one mode.
4. Optional: Select other I/O(s) to copy the same settings.
5. Click Save.
Network Traffic Camera Configuration Manual
38