Non-Visible Panic Alarm Station Configuration Guide
7
Steps
Note
The network mode is multiple networks mode, you can set the basic network parameters for
NIC 1 and NIC 2.
1. Click
to enter the Remote Configuration page, go to Network → General.
Figure 3-2 Network Basic Settings Page
2. Select the NIC and the NIC type.
3. Set the network address.
–
Automatically obtain the network address
Check Auto-obtain, the device automatically obtains the network address (IPv4 Address,
Subnet Mask (IPv4), Gateway Address (IPv4)) through DHCP.
Note
NIC 1 and NIC 2 are independent of DHCP.
–
Manually set the network address
According to the actual network environment, manually set the network address IPv4
Address, Subnet Mask (IPv4), Gateway Address (IPv4).
4. Set the MTU(Byte), Device Port, HTTP port, RTSP port for the device.
MTU(Byte)
