HIKVISION DS-C12L Series, Руководство пользователя, Страница: 23 / 43

Steps
1. Run and log in to the client.
2. Click Device Management. Online devices on the same network segment are searched out and
displayed in the lower area.
3. Select the desired device and click Add to Client.
4. Set the nickname, enter the IP address, user name, and password, and click Add.
2.4.2 Add a Device Using Its IP Address
If your device is activated with its default IP address changed, you can use the new IP address to
add it to the client.
Before You Start
• Your device has been activated.
• You have installed the Video Wall Client.
Steps
1. Run and log in to the client.
2. Click Device Management.
3. In the Managed Device area, click Add Device.
4. Enter the nickname, IP address, user name, and password, and click Add.
2.5 Configure Network Parameters
After your device is added to the client, you can configure network parameters of your device as
needed, including the IP address, subnet mask, and gateway.
Steps
1. On the Device Management interface, select the desired device in the list and click Remote
Configuration.
2. Click Network → General .
3. Configure the network parameter, including the IP address, subnet mask, and gateway.
4. Click Save.
2.6 Configure Cascading Topology
A single device supports a maximum four signal output interfaces at most which are used to
connect to a four-screen video wall. If the video wall has more than four screens, you can cascade
multiple devices and configure their cascading topology on the client. Firstly connect loop cables
and sync cables for the devices physically, and then configure the cascading topology on the client
accordingly. A maximum four devices can be cascaded.
Video Wall Controller User Manual
14