HIKOKI VB 3616DA, Инструкция по эксплуатации

Страница: 66 / 72

English
66
MAINTENANCE AND INSPECTION
CAUTION
Be sure to turned o ff the switch and remove the battery before maintenance and
inspection.
1. Inspecting the cutter
Continued use of a dull or damaged cutter will result in reduced cutting e ffi ciency and may
cause overloading of the motor. Replace the blade with a new one as soon as excessive
abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened. Should
any of the screws be loose, retighten them immediately. Failure to do so could result in
serious hazard.
3. Maintenance of the motor
The motor unit winding is the very “heart” of the power tool. Exercise due care to ensure the
winding does not become damaged and/or wet with oil or water.
4. Inspection of terminals (tool and battery)
Check to make sure that swarf and dust have not collected on the terminals.
On occasion check prior, during and after operation.
CAUTION
Remove any swarf or dust which may have collected on the terminals.
Failure to do so may result in malfunction.
5. Cleaning on the outside
When the power tool is stained, wipe with a soft dry cloth or a cloth moistened with soapy
water. Do not use chloric solvents, gasoline or paint thinner, for they melt plastics.
6. Storage
Store the power tool in a place in which the temperature is less than 40°C and out of reach
of children.
NOTE
Storing Lithium-ion Batteries
Make sure the batteries have been fully charged before storing them.
Prolonged storage (3 months or more) of batteries with a low charge may result in
performance deterioration, signi fi cantly reducing battery usage time or rendering the
batteries incapable of holding a charge.
However, signi fi cantly reduced battery usage time may be recovered by repeatedly
charging and using the batteries two to fi ve times.
If the battery usage time is extremely short despite repeated charging and use, consider
the batteries dead and purchase new batteries.
CAUTION
In the operation and maintenance of power tools, the safety regulations and
standards prescribed in each country must be observed.
00Book̲VB3616DA̲ChS.indb 66 00Book̲VB3616DA̲ChS.indb 66 2019/10/09 14:11:33 2019/10/09 14:11:33