HIKOKI VB 3616DA, Инструкция по эксплуатации

Страница: 62 / 72

English
62
[Adjusting for the sizes of rebars]
Although the bend angle is the same on the dial, the angle will slightly change depending
on the rebar’s thickness.
Adjust the angle in accordance with the size color on the setting dial.
Size of rebar Colors of indicated marks
ø10 mm White
ø12 mm Green
ø16 mm Silver
NOTE
Even at the same dial setting position, the bending angle can sometimes di ff er if the diameter
or hardness of the rebar is di ff erent. Use the angle marks merely as a rough guideline.
(7) Properly setup by placing the rebar against the guide’s stopper ( Fig. 38 on page 60 )
(8) Press the switch lock to release the lock and pull the switch to bend the rebar. ( Fig. 14, 15
on page 54 )
Even after the rebar is bent, the motor will reverse-rotate and the roller will return to position
while the switch is pulled.
When the roller begins returning to position, it will continue to do so even if the switch is
released.
(See “1. Switch operation” on page 54)
2. Bending in Manual Mode
In addition to “bending according to dial setting”, this tool uses a variable speed switch to
allow the bending of rebars according to “visual estimation”.
After steps (1) through (5) of “1. Normal bending procedure” on page 60, 61 have been
completed, follow the instructions below.
(1) Set the setting dial to a larger angle Ⓛ than the one desired Ⓡ ( Fig. 42 )
(2) Set the rebar and release the switch lock (See “1. Switch operation” on page 54)
(3) Pull the switch and release at the desired angle Ⓡ ( Fig. 43 1
)
The roller will move as long as the switch is pulled. Little by little, pull the switch a few times
to adjust until the desired angle is reached.
Setting dial
Alignment position
Fig. 42
Ⓡ
Ⓛ
3
1
2
Bending roller
Rebar
Fig. 43
Ⓛ
Ⓡ
00Book̲VB3616DA̲ChS.indb 62 00Book̲VB3616DA̲ChS.indb 62 2019/10/09 14:11:32 2019/10/09 14:11:32