English
48
CAUTION
If not tightened
fi
rmly enough the motor head might suddenly move or slip,
causing injuries. Be sure to tighten the motor head section enough so it will not
move.
(2) Make
fi
ne adjustments to the bevel angle by gripping the handle and moving the knob (A).
NOTE
Turning knob (A) clockwise, allows
fi
ne adjustment of the main unit to the left (as seen from
front).
Turning knob (A) counterclockwise, allows
fi
ne adjustment of the main unit to the right (as
seen from front).
If you tilt the main unit in the direction that does not place a load on plate (A) and pull plate
(A), the contact position changes and the right slope angle becomes 3°.
If you tilt the main unit in the direction that does not place a load on plate (B) and pull plate
(B), the contact position changes and the right slope angle becomes 48°.
(3) After adjusting to the desired angle, tighten the clamp lever and clamp the motor head.
CAUTION
Always check that the clamp lever is secured and the motor head is clamped. If
you attempt angle cutting without clamping the motor head, then the motor head
might shift unexpectedly causing injuries.
13. Compound cutting procedures
Compound cutting can be performed by following the instructions in 10 and 11 above. For
maximum dimensions for compound cutting, refer to “SPECIFICATIONS” table.
CAUTION
Always secure the workpiece with the right hand side for compound cutting. Never
rotate the table to the right for compound cutting, because the saw blade might
then contact the clamp or vise that secures the workpiece, and cause personal
injury or damage.
14. Installing the holders (Optional
accessory)
The holders help keep longer
workpieces stable and in place
during the cutting operation.
(1) As indicated in
Fig. 22
, use a steel
square for aligning the upper edge
of the holders with the base surface.
Loosen the 6 mm wing nut. Turn a
height adjustment bolt 6 mm, and
adjust the height of the holder.
Holder
(Optional
accessory)
6 mm Wing Bolt
(Optional accessory)
Steel Square
6 mm Wing Nut
(Optional accessory)
Height Adjustment
Bolt 6 mm
(Optional accessory)
Base
Surface
Fig. 22
000Book̲C12LCH̲ChS.indb 48
000Book̲C12LCH̲ChS.indb 48
2018/03/27 17:48:23
2018/03/27 17:48:23