English
44
WARNING (Fig. 11 and Fig. 12)
○
Make sure before plugging the power
plug into the receptacle that the main
body and the laser marker are turned
o
ff
.
○
Exercise utmost caution in handling
a switch trigger for the position
adjustment of the laser line, as
the power plug is plugged into the
receptacle during operation.
If the switch trigger is pulled
inadvertently, the saw blade can
rotate and result in unexpected accidents.
○
Do not remove the laser marker to be used for other purposes.
CAUTION
○
Laser radiation - Do not stare into beam.
○
Laser radiation on work table. Do not stare into beam. If your eye is exposed
directly to the laser beam, it can be hurt.
○
Do not dismantle it.
○
Do not give strong impact to the laser marker (main body of tool); otherwise, the
position of a laser line can go out of order, resulting in the damage of the laser
marker as well as a shortened service life.
○
Keep the laser marker lit only during a cutting operation. Prolonged lighting of the
laser marker can result in a shortened service life.
○
Use of controls or adjustments or performance of procedures other than those
speci
fi
ed herein may result in hazardous radiation exposure.
NOTE
○
Perform cutting by overlapping the ink line with the laser line.
○
When the ink line and the laser line are overlapped, the strength and weakness of light
will change, resulting in a stable cutting operation because you can easily discern the
conformity of lines. This ensures the minimum cutting errors.
○
In outdoor or near-the-window operations, it may become di
ffi
cult to observe the laser line
due to the sunlight. Under such circumstances, move to a place that is not directly under
the sunlight and engage in the operation.
○
Do not tug on the cord behind the motor head or hook
your
fi
nger, wood and the like around it; otherwise, the
cord may come o
ff
and the laser marker may not be lit up.
○
Check and make sure on a periodic basis if the position
of the laser line is in order. As regards the checking
method, draw a right-angle ink line on the workpiece with
the height of about 38 mm and the width of 89 mm, and
check that the laser line is in line with the ink line [The
deviation between the ink line and the laser line should
be less than the ink line width (0.5 mm)] (
Fig. 13
).
Fig. 11
Fig. 12
Laser line
Marking (pre-marked)
Fig. 13
000Book̲C12LCH̲ChS.indb 44
000Book̲C12LCH̲ChS.indb 44
2018/03/27 17:48:22
2018/03/27 17:48:22
