English
43
CAUTION
Never lift the lower guard while the saw blade is rotating.
The sub fence will not only make contact and adversely a
ff
ect cutting accuracy,
this could also result in damage to the guard.
7. Position adjustment of laser line
Ink lining can be easily made on this tool to the
laser marker. A switch lights up the laser marker
(
Fig. 9
).
Turning on the laser marker switch while the
digital display switch is on, light up the laser
marker. (On the C12FCH, only the laser marker
switch.)
Depending upon your cutting choice, the laser
line can be aligned with the left side of the
cutting width (saw blade) or the ink line on the
right side.
The laser line is adjusted to the width of the saw blade at the time of factory shipment.
Adjust the positions of the saw blade and the laser line taking the following steps to suit the
use of your choice.
(1) Light up the laser marker and make a groove of about 5 mm deep on the workpiece that is
about 38 mm in height and 89 mm in width. Hold the grooved workpiece by vise as it is and
do not move it.
(2) Then insert a 4 mm hex. bar wrench in the
12 diameter hole on the side of the gear case,
turn the hex. socket set screw to move the
laser line. (If you turn the Hex. socket screw
clockwise, the laser line will shift to the right
and if you turn it counterclockwise, the laser
line will shift to the left.) When you work with
the ink line aligned with the left side of the saw
blade, align the laser line with the left end of
the groove (
Fig. 10
). When you align it with the
right side of the saw blade, align the laser line
with the right side of the groove.
(3) After adjusting the position of the laser line, draw a right-angle ink line on the workpiece
and align the ink line with the laser line. When aligning the ink line, slide the workpiece little
by little and secure it by vise at a position where the laser line overlaps with the ink line.
Work on the grooving again and check the position of the laser line. If you wish to change
the laser line’s position, make adjustments again following the steps from (1) to (3).
Switch
(For laser marker)
Switch
(For Digital display)
(Only C12LCH)
Fig. 9
4 mm Hex. Bar
Wrench
Laser line
Groove
Fig. 10
000Book̲C12LCH̲ChS.indb 43
000Book̲C12LCH̲ChS.indb 43
2018/03/27 17:48:22
2018/03/27 17:48:22