English
41
(2) During bevel and compound cutting, attach the dust
bag at a right angle to the base surface as shown in
Fig. 4
.
CAUTION
Empty the dust bag frequently to prevent the duct
and the lower guard from becoming clogged.
Sawdust will accumulate more quickly than
normal during bevel cutting.
6. Installation
Ensure that the machine is always
fi
xed to bench.
Attach the power tool to a level, horizontal work bench.
Select 8 mm diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 35 mm plus the thickness of the work bench.
For example, use 8 mm × 60 mm bolts for a 25 mm thick work bench.
ADJUSTING THE POWER TOOL PRIOR TO USE
CAUTION
Make all necessary adjustments before inserting the plug in the power source.
1. Check to see that the lower guard operates smoothly
PRACTICAL APPLICATIONS
WARNING
○
To avoid personal injury, never
remove or place a workpiece on the
table while the tool is being operated.
○
Never place your limbs inside of
the line next to warning sign while
the tool is being operated. This may
cause hazardous conditions (see
Fig. 5).
CAUTION
○
It is dangerous to remove or install the workpiece while the saw blade is turning.
○
When sawing, clean o
ff
the shavings from the turntable.
○
If the shavings accumulate too much, the saw blade from the cutting material will
be exposed. Never subject your hand or anything else to go near the exposed
blade.
1. Tightly secure the material by vise assembly to be cut so that it does not move during
cutting
2. Switch
operation
Pulling the trigger turns the switch on. Releasing the trigger turns the switch o
ff
.
Dust Bag
Base
Duct
Right Angle
Fig. 4
Line
Line
Warning Sign
Warning Sign
Fig. 5
000Book̲C12LCH̲ChS.indb 41
000Book̲C12LCH̲ChS.indb 41
2018/03/27 17:48:22
2018/03/27 17:48:22