5
32
11
26
6
14
English
Fig. 2b
Fig. 2d
Fig. 3
Fig. 2c
◌ Grasp the handle I (5) firmly and slowly tilt saw downward until the saw is balanced on the ground. (Fig. 2b-2c)
◌
Grasp the stand support assembly (26) and lift it up until two other stand legs (11) leaving off the ground, then fold out two stand legs
(11). To do this, push the lock pins (32) until they unlock the stand legs (11) from the holes, then swing the stand legs (11) downward
until the stand legs are locked with the lock pins (32) engage the holes. (Fig. 2c) Make sure the table saw is balanced with four leg
stands stand on the floor.
◌ Fig. 2d is the leg stand assembly in an open position.
With the stand open, resting on a level surface, the stand should not move or rock from side to side. If the stand rocks from side to side,
the adjustable foot (6) need adjusting until the stand is balanced.
◌ Lift the stand slightly so that you may turn the adjustable foot (6) until the stand no longer rocks.
◌ Turning clockwise will lower the foot.
◌ Turning counter-clockwise will raise the foot.
TO SECURE/LEVEL THE STAND (Fig. 3)
WARINING:
Keep your fingers clear of the hinge points while opening the stand. Danger of fingers being crushed or contused.
WARINING:
The table saw must be secured. A table saw that is not properly secured may move or tip over.
