51
54
26
51
45
52
53
50
12
English
This product requires assembly.
◌ Carefully lift saw from the carton and place it on a level work surface.
◌ Inspect the tool carefully to make sure that no breakage or damage occurred during shipping.
◌ Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool.
◌
The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has influenced the settings, refer to
specific procedures explained in this Operator’s Manual.
◌
If any part is missing or damaged, do not attempt to assemble the table saw, plug in the power cord, or turn the switch ON until the
missing or damaged part is obtained and is installed correctly.
Items not supplied
◌
Flat head screwdriver
◌
Screwdriver
◌
13mm wrench / Adjustment wrench
◌
Framing square
◌
Triangle square
Fig. 1a
Fig. 1b
Items supplied
◌
Blade wrench (2 pc)
◌
2.5mm Hex key (1 pc)
◌
4mm Hex key (1 pc)
◌
5mm Hex key (1 pc)
UNPACKING YOUR TABLE SAW
YOU WILL NEED
◌
Place cardboard or an old blanket on floor in order to protect the surface of the working table.
◌
Place the table saw assembly (50) upside down on the protective material.
◌
Attach the stand assembly (51) to the table saw assembly (50) with four flat round head screws M8 x 45 (52) and four lock nut M8 (53)
(two holes on the side board of the stand assembly located on the blade wrench storage). (Fig. 1a)
◌
Attach the tubes of the stand support assembly (26) with the corresponding tubes (located on side of blade wrench storage (45)) on
the stand assembly (51) and align the holes. Insert the flat round head screws M8 x 10 (54) into the hole and tighten with 5mm hex key.
(Fig. 1b)
ASSEMBLE THE STAND (Fig. 1a-1e)
CAUTION:
This tool is heavy. To avoid back injury, lift with your legs, not your back, and get help when needed.
WARINING:
Remove the protective polyfoam from between the saw’s housing and the motor.
WARINING:
The use of attachments or accessories not listed in this manual might be hazardous and could cause serious personal
injury.
WARINING:
Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or
modification is misuse, and could result in a hazardous condition leading to possible serious personal injury.
WARINING:
Do not connect to the power supply until assembly is complete. Failure to comply could result in accidental starting and
possible serious personal injury.
WARINING:
Always make sure the table saw is securely mounted to the stand. Failure to heed this warning can result in serious
personal injury.
WARINING:
To avoid injury, do not connect this table saw to a power source until it is completely assembled and adjusted and you
have read and understood the operator’s manual.
CAUTION:
Many of the illustrations in this manual show only portions of the table saw. This is intentional so that we can clearly show
points being made in the illustrations. Never operate the saw without all guards securely in place and in good operating
condition.
ASSEMBLY
