HIKOKI C 10RJ, Инструкции по безопасности и руководство пользователя

Страница: 18 / 33

79
15
78
78
79
80
15
18
3
37
A
B
B
A
C
C 42
49
81
81
81
81
81
81
A
B
B
A
C
C
18
English
Fig. 9a Fig. 9b
Fig. 10a Fig. 10b
◌ Loosen and remove two stop screws (78) on the extension poles (79) of the outfeed support (15).
◌ Loosen the locking knobs (80) under the working table counterclockwise.
◌ Insert the rear extension poles (79) into the two holes in the rear of the working table and into the extension tube brackets that are
located under the working table.
Position the outfeed support (15).
◌ Thread the locking knobs (80) into the holes under the working table and tighten them.
◌ Thread the two stop screws (78) into the holes located on ends of the extension poles (79) and tighten them.
CAUTION: There are three position screws (81) (position A, B, C) on the each front and rear fence rails (42, 49) to attach rip fence.
Position screws (81) (position A and B) use for rip fence on the right of saw blade. Position screws (81) (position C) use
for rip fence on the left of saw blade. (Fig. 10b)
CAUTION: The rip fence should be parallel to the saw blade. If not, refer to the section “ Aligning rip fence to blade ” (Page 29).
CAUTION: Three position screws (81) (position A, B, C) apply to three different scales:
Position screw (Position A): Begin with 0 to 680 mm end. (Rip fence located on the right of the blade)
Position screw (Position B): Begin with 200 mm to 880 mm end. (Rip fence located on the right of the blade)
Position screw (Position C): Begin with 0 to 440 mm end. (Rip fence located on the left of the blade)
OUTFEED SUPPORT ASSEMBLY INSTALLATION (Fig. 9a-9b)
◌ Push down the fence rails lock lever (37) toward the rear of the saw to unlock it.
◌ Open the rip fence lock levers (3) located on two ends of the rip fence (18), then remove the rip fence (18) from the front and rear fence
rails (42, 49).
◌ Align the fence slots (82) with the position screws (front and back) on the fence rails.
◌ Push the slots (82) down onto the position screws and secure the rip fence in place by pushing the rip fence lock levers (3) down.
◌ Lock the fence rails lock lever (37).
RIP FENCE INSTALLATION (Fig. 10a-10c)