English
31
2. Set the switch to the “ON” position (Fig. 14)
The motor will start operating when the washer is
switched on. The motor will automatically switch o
ff
once su
ffi
cient water pressure has built up inside the
washer.
3. Pull the trigger (Fig. 15)
Hold the trigger gun
fi
rmly in both hands, point the
nozzle at the item to be washed, and then pull the
trigger.
The high-pressure water jet will spray out.
Adjust the nozzle between “Jet” and “Spray” in
accordance with need.
Trigger stopper (Fig. 16)
The trigger gun is
fi
tted with a trigger stopper to prevent
the trigger from being pulled.
The trigger is locked and released by pressing the
stopper in the direction shown by the arrows.
NOTE
Lock the trigger with the trigger stopper during pauses and
after washing has been completed.
ON COMPLETION OF USE
Once the targeted item has been washed, drain the residual water from the washer and store it in
a well-ventilated location to dry.
There are cases in which water left in the hose may freeze during the winter, so drain as much
water as possible and store it indoors.
WARNING
Make sure all residual water is drained from the washer, the trigger gun and the
hose, etc., after use.
Failure to observe this may result in freezing, leading to malfunctions.
Fig. 14
Switch
Fig. 15
Fig. 16
Push
Trigger
stopper
Trigger
stopper
Trigger
Trigger
Push
Lock
Release
000Book̲AW100̲ChS-GB.indb 31
000Book̲AW100̲ChS-GB.indb 31
2018/03/27 18:32:03
2018/03/27 18:32:03
