English
28
2. Attaching the high-pressure hose to the washer’s water outlet (Fig. 6)
Both ends of the high-pressure hose have the same
con
fi
guration, so either end may be connected.
Remove the water outlet cap from the washer, insert
the high-pressure hose into the water outlet and then
rotate the high-pressure hose ring to
fi
x it in place.
NOTE
○
Moisten the O-ring with water if it is di
ffi
cult to insert
the hose.
○
If it is not possible to tighten the ring, it means that the
high-pressure hose has not been inserted far enough.
3. Attach the high-pressure hose to the trigger gun.
(Fig. 7)
Grip the thick end of the high-
pressure hose, insert it into the
connector on the trigger gun, and
then rotate the ring on the hose to
fi
x it in place.
NOTE
○
Moisten the O-ring with water
to facilitate the connection if it is
di
ffi
cult to insert the hose.
○
If the ring cannot be tightened, it means that the end of the high-pressure hose has not
been su
ffi
cient inserted.
4. Attach the nozzle to the trigger gun.
<Attachment (
Fig. 8
)>
(1) Align the protrusion on the nozzle with the entry hole on
the trigger gun and press it into place.
NOTE
○
Remove all dirt, mud and other matter from the trigger
gun’s entry hole and the protrusion on the nozzle.
○
Moisten the O-ring with water to facilitate the connection
if it is di
ffi
cult to insert the nozzle.
(2) Press
down
fi
rmly on the nozzle and then rotate it in the
direction of the arrow until it stops (half rotation.)
(3) Check to make sure that the nozzle cannot be pulled out
once it has been attached.
<Detachment (
Fig. 9
)>
Press
down
fi
rmly on the nozzle and then rotate it
counter-clockwise until it stops. The nozzle can be
withdrawn at that position.
Fig. 6
Water outlet cap
Water outlet
Ring
O-ring
Fig. 7
Connector
Tighten
O-ring
Ring
Trigger gun
Fig. 8
O-ring
Nozzle
Protrusion
Trigger gun
1
3
2
Fig. 9
Trigger gun
Nozzle
1
3
2
000Book̲AW100̲ChS-GB.indb 28
000Book̲AW100̲ChS-GB.indb 28
2018/03/27 18:32:03
2018/03/27 18:32:03
