English
27
7. Attaching the handle (Fig. 3)
Align the handle with the groove on the washer
and then
fi
rmly tighten both screws with a Phillips
screwdriver.
INSPECTIONS PRIOR TO USE
WARNING
Check the following before using the washer. Check the items listed in 1 and 2
before plugging into the power socket.
1. Check to make sure the switch is at the “OFF” position (Fig. 4)
Plugging the washer into the power socket
with the switch set at “ON” will cause the
washer to immediately begin operating,
which may result in unexpected injuries.
2. Check the power supply
Only use a rated voltage.
Do not use motor engines are direct current.
Failure to observe this will not only result
in damage to the washer, it is also very
dangerous.
3. Check the power socket
If the power socket is loose or the plug is easily dislodged, it needs to be repaired.
It is dangerous to use it in this condition. Consult with your local electrical engineering
outlet.
ATTACHING PARTS
Make sure all parts are correctly attached in the following sequence in order to guarantee safe
usage.
WARNING
Switch
o
ff
the washer and disconnect it from the power socket without fail to
prevent unexpected accidents.
1. Attach the water feed connector to the
water feed inlet on the washer (Fig. 5)
Remove the cap on the washer’s water feed
inlet and
fi
rmly attach the water feed connector.
Loose connections may result in water leaks.
Fig. 3
Handle
Screw
Fig. 4
Power plug
Switch
Fig. 5
Water feed inlet cap
Water feed
connector
Tighten
Water feed inlet
000Book̲AW100̲ChS-GB.indb 27
000Book̲AW100̲ChS-GB.indb 27
2018/03/27 18:32:02
2018/03/27 18:32:02
