HIK VISION Pyronix Enforcer V10, Расширенное руководство по программированию

Страница: 6 / 56

6
Enforcer V10 Programming Guide
Codes and users
Changes the ‘Engineer code’, ‘Master Manager code’ and ‘Duress codes’. To change user codes enter the Master
Manager menu and scroll to ‘EDIT USERS’.
Change outputs
Programs any outputs and assigns output modules to the Enforcer.
Diagnostics
Displays power, input status, wireless arming stations, wireless signal strength and wireless battery levels.
Communications
Enables a modem (if connected), allows signalling via communication formats or SMS, and enables the Pro
App and Cloud. Please refer to the ‘Communications Guide’.
GENERAL INFORMATION
Default Codes
User: ‘Blank’
Master Manager: 2222
Engineers: 1111
Initial Power Up
Power up the Enforcer system, an alarm will be generated. Proceed to the Enforcer keypad, which will display (from
power up):
1. Once power has been applied to the Enforcer, ‘Please Wait’ will be displayed, followed by ‘485 Comms Lost’.
After approximately one minute, the Enforcer will the time on the display, indicating the system is ready to
use.
2. The Enforcer is defaulted to keypad address ‘0’.
Testing The Keypad
With the system unset, press the

key for 5 seconds at any keypad. This will cause all the LEDs on that keypad to
illuminate, and the LCD screen to display each pixel. The keypad will revert to normal display after the test which
will last about 10 seconds.
Wired Keypads/Readers