HIK VISION Pyronix Enforcer V10, Расширенное руководство по программированию

Страница: 31 / 56

31
Enforcer V10 Programming Guide
6. ‘Do Battery Load Test’ will be displayed. Press

to perform a battery load
test, the voltage will be displayed, followed by ‘Battery Passed’ if the test has
been successful. Press

.
7. ‘Test Outputs’ will be displayed. Press

to perform a test on any output
type. For example if ‘0006’ is entered, and the

key is pressed, a ‘Confirmed
Any’ test will be activated. Press

to cancel the test.
8. Press

to go back to the Engineer menu.
Test Communications
1. Press

or

to scroll to ‘ENGINEER TESTS’. Press

.
2. ‘Sound to play’ will be displayed. Press

.
3. ‘Walk Test’ will be displayed. Press

.
4. ‘Soak Test’ will be displayed. Press

.
5. ‘Test Siren’ will be displayed. Press

.
6. ‘Do Battery Load Test’ will be displayed. Press

.
7. ‘Test Outputs’ will be displayed. Press

.
8. ‘Test Communications’ will be displayed. Press

to send a test signal to
the ARC.
9. Press

to go back to the Engineer Menu.
DIAGNOSTICS
This option enables the engineer to perform full diagnostics on all key wired and wireless components of the
system.
Wireless Devices
View Inputs
This option views the status of all wireless inputs: O=Open, C=Closed, T=Tamper, F=Fault, S=Supervision fault and
B=Battery fault.
Signal Strength
This option is used to view the signal strength for any wireless input, bell or arming station that is learnt to the
system. The signal strength is shown on both the individual wireless device and on the panel in the following ways:
If a Green LED is shown on the peripheral, the signal strength is HIGH.
If a Red LED is shown on the peripheral the signal strength is LOW / NONE.