HIK VISION Pyronix Enforcer V10, Расширенное руководство по программированию

Страница: 52 / 56

52
Enforcer V10 Programming Guide
NO. TYPE ACTIVE RESTORE
0051 Line Fault When Line Fault signalled by
communicator When fault clears
0052 Mains Fail After pre-set time without mains
power On restoration of mains
0053 Battery Faults When battery disconnected or
load fail detected At next valid code entry
0054 Low Volts When the input voltage from the
transformer is too low When the control panel reads the
correct voltage.
0055 "Global Fault 1
(Faults: Modem, Battery,
Fuse, Line, Mains)" At fault When fault clears
0056 "Global Fault 2
(Faults: as above)" Activates if fault occurs only
when system is armed When all faults cleared
0058 Guard Code Used When ‘guard’ code accepted After 60 seconds
0059 Engineer Access When entering Engineer Mode Leaving Engineer Mode
0060 Initialise Digi At power up Live for 45 seconds only
0063 Test ATE/GSM Test signalling through PSTN and
GSM. Activates when a test call is
sent.(Only used for specific GSMs) When test completed
0064 "Test ATS
For use with ATE
complying with BSIA
Form 175 to initiate
test call to ARC by each
available path." Test signalling through PSTN and
GSM. Activates when a test call
is sent. When test completed
0066 ATE not used N/A N/A
0170-
0199 User Defined 1-30 Can be used to trigger outputs via the keyfob. For example, an output
can be programmed as type ‘[0171] User Defined 02’ and then wired
to a garage door. If a user keyfob button is programmed as ‘[0171]
User Defined 02,’ when that button is pressed, the output will trigger
opening the garage door.
0600-
0609 Timers 01-10 For future development
0610-
0619 Calendar 01-20 For future development
0620-
0639 Logic Gate 01-20 For future development
0640-
0649 Delay 01-10 For future development
1xxx Follow Input xxx When input is activated When input clears