14
strongest acid and 1 for the weakest. Using
[alkaline] to increase and [acidic] to decrease, select
the desired value and press [neutral] + [alkaline] to
enter.
c) Alkaline level preset adjustments:
i. [neutral] + [acidic], press [alkaline] or [acidic] to
access level 1 (display 0005), level 2 (display 0006),
level 3 (display 0007), and level 4 (display 0008).
ii. once the desired preset level is displayed, press
[neutral] to display current preset value of 1 to 100.
iii.
use [alkaline] or [acidic] to index to desired power
and press [neutral] + [alkaline] to enter value.
IMPORTANT – ALWAYS USE SUPPLIED TEST
KIT TO MEASURE RESULTING pH AFTER
ADJUSTING THE PRESETS.
13.
Trouble shooting – It is not likely that you will experience
any problems with your new Gio-Bella, but in the event you do,
refer to the chart below before calling your dealer:
SYMPTOM
POTENTIAL CAUSES
SOLUTION
Water is turned on but nothing
happens.
Diverter valve button not pulled
out.
Rear panel main power switch is
OFF.
Fuse has blown.
Circuit breaker has tripped.
Hose from diverter connected at
acid discharge instead of water
input.
Verify that water is on and that
divert button is pulled.
Verify that rear panel main power
is ON.
Verify that water hose is correctly
connected to “Water Inlet” and
secured with clamp.
Check for power at outlet by
plugging in something known to
work.
Remove fuse and verify OK
condition. Replace fuse with
250 V @1 amp if burned out.
Notify your dealer if none of the
above solves the problem.
Filter life indicator still reads 9999
even though I changed the filter.
Filter life counter was not reset
during filter change.
Press and hold red filter "Reset"
button with power on until
indicator reads 9999.
The ionized water has developed
a fishy or otherwise objectionable
smell or taste.
There is too high a level of
alkaline minerals.
Filter cartridge is depleted.
Use a lower ionization level. If no
improvement, replace filter
cartridge. Replace or start using
the calcium cartridge. Check with
