Hifonics Brutus Series, Руководство пользователя

Страница: 19 / 32

19
ELECTRICAL INTERCONNECTION
INSTALLATION INSTRUCTIONS
4
1
2
3
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wire kits. Ensure a sufficient profile section
(at least 35 mm
2
), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and remove rust-
streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are fixed tight after
the installation, because loose connections cause malfunctions, insufficient power supply or interferences.
LOGO
This push button switches the logo illumination on the upper side from blue to white.
GND
Connect the GROUND terminal with a suitable contact ground point on the vehicle’s chassis. The ground wire must be as short
as possible and must be connected to a blank metallic point at the vehicle’s chassis. Ensure that this ground point has a stable
and safe electric connection to the negative “–”pole of the battery. Check this ground wire from the battery to the ground point if
possible and enforce it if required. Use a ground wire with a sufficient cross section (at least 35 mm
2
) and the same size like the
plus (+12V) power supply wire.
REM
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your head unit with the REM-terminal of the
amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
2
). Hereby the amplifier turns on or off with your
headunit.
BATT+12V
Connect the BATT+12V-terminal with the +12V pole of the vehicle’s battery. Use a suitable cable with a sufficient cross section
(at least 35 mm
2
) and install an additional in-line fuse. For safety reasons the distance between the fuseblock and the battery
should be shorter than 30 cm. Do not set in the fuse into the fuseblock until the installation is accomplished.
WARNING The amplifiers BRX4000D, BRX6000D and BRX 9000D have due to construction-conditioned reasons no internal fuse-
protection. The amplifiers must necessarily be fused with an external In-Line-Fuse.
The fuse rating always depends on the total impedance. Please refer to our recommended fuse ratings on page 26.
1 3 2 4
POWER INPUT
SPEAKER OUTPUT
PROTECT
POWER
SLAVE MASTER
LP LEVEL
BASS LEVEL
CONTROLLER
AUTO TURN ON
(ONLY IN HI LEVEL INPUT MODE)
0dB 18dB
LINE IN SLAVE IN/OUT
LEVEL
INPUT
MODE
35Hz 250Hz
L
R
MIN MAX
OFF
ON
LOW
HI
SUB
BOOST Q-CONTROL PHASE
FREQ.
RANGE SUB SONIC
15Hz 55Hz
GND +12V REM
EXTENDED BASS CONTROL
WIDE NRW 20Hz 80Hz 0 ° 180 °
BALANCED
INPUT
BRX4000 D
L
R
BRX4000 D
BLUE / WHITE
LOG0
IMPORTANT NOTE