Installation BN48-IP66
16
Release 01 11/2019
2.4
Operating the device
By connecting the supply voltage via a connector, you start the operation
of the device.
Proceed as follows:
Connect the power supply cable.
Enable the supply voltage.
2.5
Connecting data cables
Note the following general recommendations for data cable connections
in environments with high electrical interference levels:
Keep the length of the data cables as short as possible.
Use optical data cables for the data transmission between the
buildings.
When using copper cables, provide a sufficient separation between
the power supply cables and the data cables. Ideally, install the
cables in separate cable channels.
Verify that power supply cables and data cables do not run parallel
over longer distances, and that ideally they are installed in separate
cable channels. If reducing the inductive coupling is necessary, verify
that the power supply cables and data cables cross at a 90° angle.
Use STP/UTP cables as per ISO/IEC 11801:2002.
