DC48V
Installation-
replacing existing lighting
[unexposed cable]
1. Dispose of existing lighting
Remove the existing embedded
fluorescent light box.
Then, leave the blue part of wire
connection (A) a bit longer.
Caution: when handling the wire,
please turn off the power.
Conventional Fluorescent
Light Box was installed
A
B
2. Appoint location of bolt hole
Drill designated product hole(s)
according to product size.
Caution: pierce the hole according
to above picture if one’s ceiling is
constituted of strong materials.
If it is wood/plaster board, one
does not need to drill holes to install.
3. Wire connection
4. Check power/product condition
5. Attach the product
6. Installation complete
Connect product’s adapter to
the wire that was previously
taken out.
Caution: when connecting
wires, please, turn off the power.
Before fixing product, turn
on the power switch and
observe the condition of
the product and product’s
performance.
Attach the product to the
ceiling by matching four bolts
to the holes. (Do not put the
adapter on the upper part
of the product. Instead, place it
inside the ceiling.)
Depending on one’s own
preference, one can freely
change film that fits the
environment (please, refer to
the film change procedure).
DC48V
Power Switch
ON
DC48V
