CAUTION:
Before replacing a DIMM, expansion board, or other similar PCA components due to a
perceived hardware error, make sure first that the component is firmly seated in the slot. Do not
bend or flex circuit boards when reseating components.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
Remove the server from the rack
on page 30.
• Server in tower mode:
Position the tower server for hardware configuration
5.
on page 32.
6.
on page 34.
7.
on page 35.
8.
Disconnect the M.2 SATA cables from the enablement board.
9.
Remove the M.2 SSD enablement board.
To replace the component, reverse the removal procedure.
56
Removal and replacement procedures
Содержание HPE ProLiant ML110 Gen10
