HES HS2510-N, Руководство пользователя

Страница: 14 / 64

12
Hwang Sun Enterprise Co., Ltd.
12 Edition 2012/02
Figure 2.5 Gear Pump
3. Heating Plate
This heat plate of HS2510-N Hot Melt Applicator is made from aluminum
material, and completely well welding at the bottom of the tank.
The heating source of the plate is from six long stick heater which be buried
inside the heating plate. Once this plate starts heating, the heat produced by heater
will disperse all over the plate, also deliver to tank and manifold to melt down the
adhesive material in the tank and keep the molten material in the setting temperature.
There are two temperature sensors [(K) CA type ] inserted in the both sides of the
tank, to pass the heat signal to PID and mechanical temperature detector to control
the operation temperature of heating system.
4. Manifold
The manifold of the HS2510 Hot Melt Applicator is bring mounted by four
socket head screws at the bottom of the tank, connected with heat plate.
This manifold can be completely separate from the tank during maintenance service.
There are several types of hot melt adhesive path inside the manifold:
Figure 2-6 Manifold