Herth+Buss 95950004, Руководство по эксплуатации

Страница: 34 / 60

Operating Instruction 95950004
www.herthundbuss.com 34
EN
proceeding. In Flash Reprogramming Mode,
the charger is able to deliver 70A charging
current continuously, and to deliver up to
100A for three minutes.
1. Set MODE to FLASH REPROGRAM. (The
VOLTS LED will start blinking.)
2. Use and to adjust voltage to
the voltage needed for the vehicle being
programmed (refer to OEM specifica-
tions). Voltage selected is shown on the
digital display. The unit has a voltage ran-
ge of 13 to 14.8, with a default of 14.2.
NOTE: When the VOLTS LED stops blin-
king, the display shows the selected vol-
tage.
3. Press to turn on the output.
4. When finished with Flash Reprogram-
ming, press to exit this mode.
Using the Battery Voltage Tester
Overview
This battery charger has a built-in voltmeter
to measure your battery’s voltage. The char-
ger does not have a built in load tester. As
such, a recently charged battery could have
a temporarily high voltage due to what is
known as “surface charge”. The voltage of
such a battery will gradually drop during the
period immediately after the charging sys-
tem is disengaged. Consequently, the tester
could display inconsistent values for such
a battery. For a more accurate reading, the
surface charge should be removed by tem-
porarily creating a load on the battery, such
as by turning on lights or other accessories
for a couple of minutes before you read the
display. Read it a couple of minutes after you
have shut the headlights off.
Testing Sequence:
There are seven basic steps required to test
the battery state of charge:
NOTE: You cannot test the battery voltage
while charging.
1. With the charger unplugged from the AC
outlet, connect the charger to the battery
following the instructions given in Sec-
tions 6 and 7.
2. Plug the charger AC power cord into the
AC outlet.
3. The CONNECTED (yellow) LED will light if
a properly connected battery is detected.
4. Confirm the CHARGING (yellow) LED is off.
5. Set the DISPLAY to VOLTS.
6. If the output is on, press . If the out-
put is already off, do not press .
7. Read the voltage on the digital display.
General Charging Notes
Fans:
The charger is designed to control its coo-
ling fans for efficient operation. Consequen-
tially, it is normal for the fans to start and
stop when maintaining a fully charged bat-
tery. Keep the area near the charger clear of
obstructions to allow the fans to operate ef-
ficiently.
NOTE: The charger has thermal protection,
and it will shut down if it gets too hot.