![background image](http://html1.mh-extra.com/html/hero/maestro-edge-125-programmed-fi/maestro-edge-125-programmed-fi_manual_2126658069.webp)
66
Wear clean gloves while replacing the bulb. If
you touch the bulb with your bare hands, clean
it with a cloth moistened with alcohol to
prevent its early failure.
•
Be sure to turn the ignition switch “OFF”
when replacing the bulb.
turned “OFF”. Be sure to let it cool down
before servicing.
•
Disconnect the headlamp connector (1).
•
Remove the headlamp case
(page 41)
.
•
Do not use bulbs other than that specified.
After installing a new bulb, check that the
lamp operates properly.
(a) Headlamp
Do not put finger prints on the headlamp bulb,
as they may create hot spots on the bulb and
cause it to break.
Refer to the safety precautions
(page 54)
.
The bulb becomes very hot while the lamp is
“ON”, and remains hot for a while after it is
BULB REPLACEMENT
•
Remove the dust cover (2).
•
Loosen the screw and release the clip (3)
from its position.
(1) Headlamp connector
•
If the replacement fuse of the same rating
burns out in a short time, there is probably a
serious electrical problem on your vehicle.
Leave the blown fuse in that circuit and have
your vehicle checked by your Authorised
Hero MotoCorp
workshop.
Inspection
SUSPENSION
•
Check the front forks by locking the front
brake and pumping the front fork up and
down vigorously. The suspension action
should be smooth and there should be no oil
leakage.
•
Check the rear shock absorber by pushing
hard downwards on rear grip while the
vehicle is not parked on stand. The vehicle
action should be smooth and there should
be no oil leakage.
Rear
Front
1