Hermle UWF 902 H, Руководство по эксплуатации

Страница: 54 / 135

3-21
2
1
3.12 Cooling System
3.12 Cooling System
The coolant tank of the UWF is located under the
cabin. It is pushed from the front into an opening of
the cabin and it has a capacity of 170 liter.
After lifting up the coolant pump the empty tank can
be pulled out and cleaned. Release the clamping
lever at the coolant pump and now the complete
device can be lifted and fixed with the clamping lever.
The coolant pump can be switched on and off in an
NC-program by using M-function M08 for switching
on, and M09 for switching off (see M-functions page
3-22). To switch on and off the coolant pump and
the spindle simultaneously, use M-function M 13
and M 14 (see also M-funstions page 3-28)
If desired the coolant can be switched on manually
by using key [8] on the keyboard (see picture page
3-4).
The board for the coolant equipment is located on the
right-hand side of the machine. Via the two valves all
coolant tubes can be fed individually.
The regulator cock [1] controls the coolant supply at
the vertical head.
A coolant nozzle with hose is optional available for the
UWF. It can be used to clean the table from dirt or
chips, for example during a stop for measuring
purposes.
The hose of the coolant nozzle can be connected to
the optional coupling [2] of the coolant control panel.
The manual coolant nozzle is now ready for use and
can be started by depressing the lever. The spray
can be adjusted by turning the nozzle tip
Danger
Use caution when working with the manual coolant
nozzle! Never point the spray towards people.