HermanMiller
Assembly Instructions
8
1BPGDV rev C
Step 4
Step 5
4.1 Drill a 1/8” pilot hole centered in slot of the 12” Shared Peninsula Leg
bracket (3/4” deep max - do not drill through top of Work Surface).
4.2 Using qty=1 #14 screw, attach the Peninsula Leg to the Work Surface
in slot.
4.3 When attached to modesty panel, the 12” shared peninsula leg will
be ~0.125” proud of edge of the peninsula work surface. This condition
is expected, as the shared peninsula leg will slide under the main work
surface when attaching the peninsula surface (steps 7 & 8).
5.1 Adjust the Leg Levelers to the same height as Levelers on the main
Work Surface .
Leveler
1/8” Pilot hole
Step 6
Step 7
6.1 Add Ganging Bracket FK29B to the main Metal Desk Work Surface (1/8”
pilot holes recommended).
6.2 Secure plate to worksurface with #10 Pan Head Screws.
#10 Pan had screw
7.1 Align work surfaces
- Slide the Peninsula Work Surface into Main Work Surface so
there is no gap between surfaces. The 12” Shared Peninsula Leg
will slide under the Main Work Surface.
7.2 Adjust Levelers up/down to achieve work surface flushness.
No gap
Ganging Plate (FK29B)
