HermanMiller
Assembly Instructions
7
1BPGDV rev C
LH/RH Peninsula Leg installation
Step 10
Step 1
10.1 Position Modesty Panel to back of leg assemblies.
10.2 Secure to legs with (8) Pan Head Sheet Metal Screws.
1.1 Peninsula desk built separately with work surface face-down (work
surface & Legs/Modesty aligned & fastened - similar to standard Canvas
Metal Desk Unit).
Modesty Panel
(FK700)
Pan Head Sheet
Metal Screw
Step 2
Step 3
2.1 Locate the End Leg on the bottom of the Work Surface.
•
Inset Leg 3/16” from Work Surface edge.
2.2 Drill 1/8” pilot holes centered in slots of the End Leg brackets (3/4” deep
max - do not drill through top of Work Surface).
2.3 Using qty=2 #14 screws, attach the End Leg to the Work Surface in the
each of the slots.
End Leg
(FK2E3)
Worksurface
(FKS34)
12” Shared
Leg
(FK2E3)
#10 Pan Head
Sheet Metal
Screws
3.1 Attach the Modesty Panel to the End Leg using #10 screws - attaching
the round hole in the Modesty first to properly locate the Panel in vertical
direction.
3.2 Attach the Modesty Panel to the 12” Shared Peninsula Leg using #10 Pan
Head Sheet Metal screws - attaching the round hole first to properly locate the
Panel in vertical direction.
Add Note: Use 1” spacer (not provided) under modesty panel while installing.
