Heritage Bathrooms Lymington TLYCG00, Руководство по установке

Страница: 9 / 20

Installation-
Basin Mixer
09
1. Identify all components are present prior to starting installation using the diagram overleaf.
2.
Fit the mixer body (7) to the basin ensuring the o-ring (9) is fitted between the basin and the mixer
body (7).
3. From the fixing kit (10), Screw the two fixing rods into the bottom of the mixer body (7). Push the
‘C’ shaped rubber and metal washers onto the threaded rods and tighten by screwing the fixing nuts
accordingly.
4. Screw in (by hand only) the flexible connecting pipes (11) to the mixer
(DO NOT OVERTIGHTEN)
and connect the hot and cold water supplies.
5. Fit the clicker waste (11) to the basin ensuring a rubber washer is fitted between the basin and the
waste. Use a pure silicon sealant where necessary. Place the other rubber washer under the basin and
secure in place by tightening the backnut. In order to fill the basin, push down the middle of the waste.
To release the water, press the middle again.
6. Lift the handle up and turn in both directions, letting the water flow for a few minutes to check all
joints and connections for any leaks.
1. Grub Screw Cap x1
2. Grub Screw x1
3. Handle x1
4. Shroud x1
5. Cartridge Retaining Nut x1
6. Cartridge x1
7. Mixer Body x1
8. Anti- Splash x1
9. ‘O’-ring x1
10. Fixing Kit x1
11. Flexible Tails x2
12. Clicker Waste (not shown) x1
1
6
5
4
7
8
9
10
11
2 3