IPS_Man_20003342641 V01 en 03.21
Page 21 of 36
ð
The internal fans are switched on.
ð
The UV lamps are preheated. After 15 seconds, the UV lamps are active and the
LEDs are lit up blue.
Optimising the air circulation
What is important for an optimal cleaning effect is good air circulation that
provides a constant flow of air but shall also not be unpleasant.
This device has built-in fans. They take the air into the device from above. The
air outlets at the front and bottom of the device then ensure creation of an op-
timal air circulation that will reach all corners of your room as far as possible.
è
Please observe the installation instructions.
è
Set the air circulation ("Optimal Air Circulation" to "Power
Mode") at the rotary control.
Please note! We recommend that you maximise the air-
flow rate only while no people are in the room ("power
mode").
Switching the device off
è
Actuate the mains switch (On/Off).
ð
The device is switched off.
Operating hours meter
The operating hours of the UV lamps are monitored.
Temperature monitoring of the control unit
A temperature monitor is integrated in the control unit. The UV lamps will be switched off
in case of overheating.
System monitoring
UV lamps, fans and control unit are monitored. The LED strip light indicates errors visu-
ally.
LED status message
The colours of the LED strip lights (top and bottom) indicate the status.
è
Observe the status message and take the appropriate action.
